Control unit for strip lamps, spotlights, bi-color led 2 channel 15A power supply 12-24V + RF Remote control Touch Wireless
Controller for led strip-tone pattern, internal use (IP20), 12v power supply, complete with RF remote control.
The function of this controller is the management of the strip-two-tone, cool-white light - warm white. The controller together with a strip two-tone allows the emission of light warm white or cold white, or mix the two colors to size to your liking the color temperature thanks to the 6 buttons of different color temperature are placed on the remote control. The controller also makes it possible to vary the luminous intensity of the light in the middle of the remote Master Dimmer RF supplied.
9 programs giiochi light available
Controller Touch remote RF Touch
The color selection is done via the touch of a circle. Simply tap the color you want to give to the apparatus (led strip, led , etc ...) the chosen color .
By using the two buttons arranged it is also possible to dim the amount of light (to reduce or increase the light intensity).
The controller works on radio frequency and therefore it is not necessary to point the remote to the controller, but will work from any point in the vicinity, even if the controller is hidden or enclosed in junction boxes.
Easy installation and intuitive.
The remote control requires 3 batteries aaa ( AAA) .
The control unit RF, operating at 12-24V dc power, it can handle a total load equal to 15A (5A per channel) thanks to 3 powerful transistor f nal MosFet.
In addition to the function of turning on and off by a remote control unit, the control unit is capable of remembering the last setting made, even if it is interrupted the power supply.
This is useful in the case in which the device is inserted in a circuit controlled by a main switch or other type of command.
You can change your choice of the color emitted by the lamps by mixing at will the colors.
It is possible to control the on-off switching by simply touching the sensor.
It is possible to adjust the intensity (dim) the intensity of the output in a gradual way, keeping a finger over the sensor for a few seconds until it reaches the desired brightness.
The connections are very simple, just connect on one side of the terminal, the 12V or 24V power supply and on the remaining terminals, your strip bi-color led
Maximum supply: dc 12-volt max 180Watt
24Volt max 360Watt
For a max distance of about 30 meters.