The new Controller RGBW with remote control, to control the comfort of LED strips, RGBW home and professional.

Using this product you can maintain in comfort, the color that white light of your strips LED RGB+W, thanks to a controller reliable and extremely powerful.

The controller works on radio frequency and therefore it is not necessary to point the remote to the controller, but will work from any point in the vicinity, even if the controller is hidden or enclosed in junction boxes.
The remote control is in a zone and can control the infinite power units (to the extent consistent with the maximum reception distance max 30 metres) by sending them the same signal.
The color selection is by the touch of the color wheel. Simply tap the color you want to give to the device (RGB led strip, led , etc ...) the chosen color .

The remote control is equipped with the following functions:

Switch function: by means of the appropriate button, you can turn off and turn on the light directly from the remote control. It is recommended however to also install a traditional switch upstream of the power supply, so you can completely remove the current from the system.

Wheel Touch: allows you to change the brightness quickly and intuitively.

Key, "Brightness": while holding down the button, you can adjust the brightness.

"W"key: it allows to obtain three shades of white (warm, natural, cold) by mixing the three primary colors in a different way.

"S"key: speed allows you to change the speed of the play of light are programmable.

"P"key: the program allows you to select the program play of light among the 8 available.

If necessary, the remote can control more than one control unit, by sending the same signal to each one. This can be useful in installations with many meters of strips, where it is necessary to control all at the same time.

Easy installation and intuitive.
The remote control requires 3 batteries aaa ( AAA) .
The ecu and RF, operating on 12-24V dc power, it can handle a total load equal to 15A

The System and the Remote Controller does not include the power supply. Must, therefore, be combined with a suitable power and voltage consistent LED strip to be powered and dimmed.